HP Indigo press 3050 User Manual page 105

4
Figure 8-6. Ink cans window
5
6
Note You can rebuild as many inks as necessary concurrently.
7
Figure 8-7. Inks Properties window
8
9
10 Remove the plug from the top of the ink tank. Add 2 ml (0.07 oz) of imaging agent and
11 In the Inks Properties window, monitor the conductivity until the conductivity reading
12 Add 0.5 ml (0.01 oz) of imaging agent and wait two minutes for the conductivity
13 Repeat step 11 until the conductivity reaches 60 to 65 pmho/cm. Automatically
104 Chapter 8 Handling ink
On the control panel, click the Consumables menu, and then select Ink Cans. The
Ink Cans window opens.
Click the panel below the name of the ink can that requires rebuilding.
Click Rebuild. The word Yes appears in the Rebuild Ink field. The next time the press
is in the Getting Ready state, ink concentrate is added at the required density to the
tank.
On the control panel, click the Diagnostics menu, and then select Ink. The
Inks Properties window opens.
Verify that the required ink pump is on. If it is not, in the Inks Properties window, click
Ink Pump to turn the ink pump on.
Open the ink cabinet door.
wait two minutes.
stabilizes.
reading to stabilize.
replenishing imaging agent keeps raising conductivity to the desired set-point
(90 pmho/cm).
ENWW