HP Indigo press 3050 User Manual page 210

2
Figure 14-13. Timing belt, 3-mm Allen screw, and front locking plate
3
4
Slot
Fit sponge roller into right end cap
Figure 14-14. Fitting sponge roller into the housing
ENWW
Remove the timing belt.
Remove the old sponge roller by pulling the roller to the right, and then forward.
Install the new sponge roller.
a Slide the roller into the housing assembly, right side first.
Left end cap
3-mm Allen screw
Front locking plate
Timing belt
Sponge roller housing
Right end cap
Slots on sponge roller
Sponge roller replacement 209