HP Indigo press 3050 User Manual page 193

6
Figure 12-3. Knock-outs removed
7
8
9
Figure 12-4. Installing impression paper
10 Rotate the impression drum so that the impression paper wraps around it.
11 Lock the duplex tray into place.
12 Lower and lock the conveyor.
13 Lock the ITM hood in place.
14 Close all doors.
15 Release the Emergency Stop button.
192 Chapter 12 Impression drum
On a new impression paper, remove all the paper knock-outs.
Loosen the special low head screws two turns using a 3-mm Allen key (Figure 12-2),
and insert the impression paper with the L mark shown on the left side of the
impression paper, facing you.
Hold the impression paper as shown in Figure 12-4. Do not bend the impression
paper during installation.
Push the impression paper up until the top of the impression paper is visible in the
indicator slot of the impression paper holder. Using a 3-mm Allen key, tighten the two
screws shown. Fasten the screws. Hold the paper in place while you fasten the
screws.
Loosen low head screws by two
turns and then insert the impression
paper as shown
Knock-outs removed
Gripper window
(lower side)
L mark faces user when
paper is installed
Push up
Indicator slot
ENWW