Checking Ink Flow - HP Indigo press 3050 User Manual

9
Figure 16-38. Removing the cleaning foil
10 After the cleaning foil is removed, rotate the developer roller, and clean it.
Reinstall the black BID (refer to the section 'Installing the BID unit' on page 225, for
details).
Perform the following procedures only when required to troubleshoot the BIDs.

Checking ink flow

The purpose of this procedure is to verify ink flow rate. The verification process consists of
two stages: checking that the ink pump is on, and setting the ink pump flow rate.
Checking the ink pump
1
2
Figure 16-39. Ink Flow Calibration – Select Ink Tank window
246 Chapter 16 Binary ink developer (BID)
Lift up the adhesive strip, and pull off the cleaning foil as you rotate the developer
roller.
In the control panel, click Adjustments, and Ink Flow Calibration to start the wizard.
Select a color, then click Next.
ENWW