Correcting An Inkless Spot On The Leading Edge - HP Indigo press 3050 User Manual

Correcting an inkless spot on the leading edge

Use the BID engage calibration to change an inkless spot in the 25 mm (1 inch) strip at
the leading edge.
25 mm (1 inch)
Figure 16-30. An inkless spot at the leading edge
Note Make sure that the spot appears in the specified area. If there is more than one spot, adjusting
the BID engage angle will not solve the problem.
Use the following procedure to correct an inkless spot on the leading edge:
1
2
3
4
5
6
7
8
9
10 In the Analyze window, increase the value in the appropriate text box by 6.
11 Click Print to print the verification BID engage calibration job. Click Finish.
12 Print the CATP job and inspect the print. Add 10 to the color bar value and repeat the
13 If the problem is not resolved, contact your customer engineer.
ENWW
Remove an
inkless spot in this
area
On the Adjustments menu, click BID Engage. The BID Engage Calibration wizard
opens.
Select the Leading Edge check box.
Click Print. Two copies of the leading edge test job are printed. Select the first copy.
Identify the missing color.
Analyze the print and note the value of the shorter bar of the missing color. Add 3 to
the read value.
In the Analyze window, enter the sum value in the appropriate color field.
Click Print. Two copies of the BID engage calibration verification are printed.
Click Finish.
Print the CATP job and inspect it. If the inkless spot has not disappeared, repeat steps
1 through 4.
procedure.
10 mm (0.39 inch)
Leading edge
Trailing edge
Adjusting the BID engage and disengage angle 237