HP Indigo press 3050 User Manual page 170

4
Figure 11-29. Fold paper in half, along its long axis, to crease it
5
6
7
8
9
10 Push down on the paper with one hand, to prevent it from moving along the conveyor,
11 Make sure that the paper crease is aligned with the zero mark on the scale, and that
12 Adjust the side knob for the rear jogger so that the jogger is parallel to the paper.
13 Open the guide knob on the rear jogger, and move the jogger until it touches the
14 Lock the guide knob on the rear jogger (Figure 11-26).
15 Attach a flat spring to the front static guide that flexes 2 or 3 mm (0.078 to 0.118 inch)
16 Make sure the flat spring screws fit within the holes during installation.
Rear jogger side knob
Front static guide side
knob
Flat spring
Figure 11-30. Flat spring installation on front static guide
ENWW
Take a sheet of paper from the Paper Feed Unit input tray, and fold it in half, and
crease it near one end.
Crease
Insert into Paper Feed Unit
input tray, creased side first
Insert the creased paper into the Paper Feed Unit, creased side first.
Push the Paper Feed button, and the Inching Forward button to advance the
creased paper.
When the creased paper is under the feed rollers of the Paper Feed Unit, push the
Paper Feed button again to stop the vacuum.
From the exit side of the Paper Feed Unit, press the Inching Forward button until the
creased paper arrives at the paper width scale (Figure 11-28).
Using your hands, align the paper crease with the zero mark on the scale, and make
sure the paper is parallel to the scale.
and press the Inching Forward button until the rear jogger moves closest to the front
of the press.
the paper is parallel to the paper width scale.
paper. Make sure the paper lays flat on the conveyor, without buckling (Figure 11-29).
when contacting the paper.
Adjusting the front static guide and rear jogger 169
Make sure the screws
fit within the holes
during installation