4
Figure 16-3. BID Diagnostic Wizard – Inks Preparation window
5
6
Figure 16-4. BID Diagnostic Wizard – BID Diagnostic window
Removing the BID unit
1
222 Chapter 16 Binary ink developer (BID)
Click the Inks Preparation start button, and wait a few minutes until the ink
parameters are adjusted.
Click Next after the ink parameters are adjusted.
After the test is completed, the results will show in the status bars. The test may take
a few minutes.
When finished, click Close.
On the control panel, click Standby.
Click here
Test results appear
in status bars
ENWW