Table of Contents
Advertisement
12 Click the Replacement Cause drop-down list. Select the reason for replacement. If
13 Click Replace. The impression counter for the blanket resets to zero.
Figure 9-12. Blanket window
14 Click Close. The Blanket window closes. The impression drum and the ITM drum
15 Use the First Transfer Calibration wizard to adjust first pressure. See 'First pressure
16 Perform the color adjust procedure.
17 Perform the print cleaner procedure.
Cleaning the blanket
Even though the blanket transfers all the ink from the PIP to the substrate, a small amount
of residue can remain on the blanket. This is primarily a result of blanket aging.
Before beginning the procedure, make sure to have the following items:
Note
Only clean the blanket when necessary. Do not clean non-contaminated areas.
Use the following procedure to clean the blanket:
1
120 Chapter 9 Blanket
none of the options are applicable, select Other and enter your reason. Avoid using
Other as much as possible. If you must use it, give a specific reason for the PIP
replacement.
Enter reason for blanket replacement
disengage.
adjustment' on page 128.
imaging oil
lint-free wipe
blanket scraper
thermal gloves
Fold the lint-free wipe four times.
ENWW
Advertisement
Table of Contents
Troubleshooting
