HP Indigo press 3050 User Manual page 211

Figure 14-15. Fitting sponge roller into the housing
5
6
Note When putting the timing belt on the pulleys, turn the pulleys until the belt lies in the middle of
the pulley (Figure 14-16).
Figure 14-16. Putting the timing belt on the pulleys
7
210 Chapter 14 Cleaning station
b Push the roller as indicated to fit it into the left end cap.
c Place the roller so that its slots sit on the housing.
Re-install the front locking plate and the 3-mm Allen screw.
Re-install the timing belt.
Re-install the cleaning station (See 'Installing the cleaning station' on page 208).
Push roller as indicated to fit it
into the left end cap
Make sure the timing belt is
centered on each pulley
ENWW