HP Indigo press 3050 User Manual page 227

5
CAUTION Do not handle the BID by its motor, which may be hot.
CAUTION Never wipe the developer roller with a dry wipe, as you will scratch it.
CAUTION Before inserting the BID unit into the press, be aware that the PIP drum may be scratched if the
BID is not inserted horizontally (straight) into its place. The PIP drum is located above the BID,
and may be scratched by the BID pins.
6
Figure 16-12. BID
Figure 16-13. BID and housing
7
8
9
10 Close the front door.
226 Chapter 16 Binary ink developer (BID)
If a BID washer is available, use it to clean the BID. If not, use a lint-free wipe soaked
in imaging oil to wipe the surface of the developer roller. Keep rotating the developer
until its surface is clean.
The BID should be inserted gently, and parallel to it's housing. Make sure that the BID
rail and pins fit into the housing slots. There are three slots that correspond to the rail,
the pin on the right side of the BID, and the pin on the left side.
BID latch
BID
handle
BID latch
Ink inlet
BID housing
Make sure that the BID is inserted all the way. If the latch is unlocked, the following
error message appears when the press changes to the Get Ready state:
BID color is not in place or unlocked
(The BID color refers to the colors shown in Figure 16-1.)
Insert the BID ink supply assembly.
Lock the ink supply latch (see Figure 16-7).
BID pin
BID rail
BID rail
BID pin slot
BID outlet
ENWW