7
Blanket leading
edge
Figure 9-4. Leading edge of blanket
8
Figure 9-5. Gently pull off the leading edge of blanket
Note
Do not use a sharp object to peel off the blanket because this can scratch the ITM drum.
116 Chapter 9 Blanket
Cut the blanket with a knife just above the outside metal clamp. Angle the knife
upwards as shown in Figure 9-4.
Metal width
behind the
blanket
Insert the needlenose pliers between the blanket and the ITM drum on the rear side
above the metal fastener bar. Peel the blanket from the drum.
BLANKET REMOVALB1
Outside
metal clamp
Cut here
Side view
ITM drum
ENWW