Installation; Installation Direction And Clearances - Mitsubishi Electric MELSERVO-J3W Series Instruction Manual

2. INSTALLATION

2. INSTALLATION
WARNING
CAUTION

2.1 Installation direction and clearances

CAUTION
When using heat generating equipment such as the regenerative option, install them with full consideration of
heat generation so that the servo amplifier is not affected.
Install the servo amplifier on a perpendicular wall in the correct vertical direction.
To prevent electric shock, ground each equipment securely.
Stacking in excess of the limited number of products is not allowed.
Install the equipment on incombustible material. Installing it directly or close to
combustibles will lead to a fire.
Install the equipment in a load-bearing place in accordance with this Instruction
Manual.
Do not get on or put heavy load on the equipment to prevent injury.
Use the equipment within the specified environmental condition range. (For the
environmental conditions, refer to section 1.3.)
Provide an adequate protection to prevent screws and other conductive matter, oil
and other combustible matter from entering the servo amplifier.
Do not block the intake and exhaust areas of the servo amplifier. Doing so may
cause faults.
Do not drop or strike the servo amplifier. Isolate from all impact loads.
Do not install or operate the servo amplifier which has been damaged or has any
parts missing.
Do not install or operate a faulty servo amplifier.
When the product has been stored for an extended period of time, contact your local
sales office.
When treating the servo amplifier, be careful about the edged parts such as the
corners of the servo amplifier.
The servo amplifier must be installed in the metal cabinet.
The equipment must be installed in the specified direction. Otherwise, a fault may
occur.
Leave specified clearances between the servo amplifier and control box inside walls
or other equipment. Doing so may cause faults.
2 - 1