Mitsubishi Electric MELSERVO-J3W Series Instruction Manual page 104

5. PARAMETERS
5.3 Extension setting parameters (No.PC
5.3.1 Parameter list
No. Symbol
PC01 ERZ Error excessive alarm level
PC02 MBR Electromagnetic brake sequence output
PC03 *ENRS Encoder output pulses selection
PC04 **COP1 Function selection C-1
PC05 **COP2 Function selection C-2
PC06 *COP3 Function selection C-3
PC07 ZSP Zero speed
PC08 This parameter is not used. Do not change the value.
PC09 MOD1 Analog monitor 1 output
PC10 MOD2 Analog monitor 2 output
PC11 MO1 Analog monitor 1 offset
PC12 MO2 Analog monitor 2 offset
PC13 This parameter is not used. Do not change the value.
PC14
PC15 SNO Station number selection
PC16 This parameter is not used. Do not change the value.
PC17 **COP4 Function selection C-4
PC18 This parameter is not used. Do not change the value.
PC19
PC20
PC21 *BPS Alarm history clear
PC22 This parameter is not used. Do not change the value.
PC23
PC24
PC25
PC26
PC27
PC28
PC29
PC30
PC31
PC32
Note 1. Each axis: Set a value for each of the A-axis and the B-axis.
Common: Common parameters for the A-axis and the B-axis. Set same values for the A-axis and the B-axis. If different values are
set, the last set value becomes valid.
2. Valid for the A-axis and the B-axis.
)
POINT
The parameter whose symbol preceded by * can be validated with the following
conditions.
* : Turn off the power and then on again, or reset the controller after setting the
parameter.
**: Turn off the power and then on again after setting the parameter.
Name
5 - 17
Factory
Setting
setting Unit
(Note 1)
(Note 2)
Each axis 0
Each axis 0
Each axis 0010h
Each axis 0000h
Each axis 0000h
Each axis 0000h
Each axis 50 r/min
0
Common 0000h
Common 0001h
Common 0 mV
Common 0 mV
0
0
Common 0
0000h
Each axis 0000h
0000h
0000h
0000h
Each axis 0000h
0000h
0000h
0000h
0000h
0000h
0000h
0000h
0000h
0000h
0000h
0000h
rev
ms