Mitsubishi Electric MELSERVO-J3W Series Instruction Manual page 296

13. USING A LINEAR SERVO MOTOR
No. Symbol
PC06 *COP3 Function selection C-3
Select the error excessive alarm level setting for parameter No.PC01.
0
PC07 ZSP Zero speed
Used to set the output range of the zero speed (ZSP-A/ZSP-B).
Zero speed (ZSP-A/ZSP-B) has hysteresis width of 20mm/s.
PC09 MOD1 Analog monitor 1 output
Used to selection the signal provided to the analog monitor 1 (MO1) output.
0 0
PC10 MOD2 Analog monitor 2 output
Used to selection the signal provided to the analog monitor 2 (MO2) output.
0 0
PC26 This parameter is not used. Do not change the value.
Set the communication method of the encoder cable (two-wire type/four-wire type)
with parameter No.PC04.
Name
0 0
Error excessive alarm level setting selection
0: 1 [mm]unit
1: 0.1 [mm]unit
2: 0.01 [mm]unit
3: 0.001[mm]unit
Analog monitor 1 (MO1) output selection
Setting
Linear servo motor speed ( 8V/max. speed)
0
Thrust ( 8V/max. thrust)
1
Linear servo motor speed ( 8V/max. speed)
2
Thrust ( 8V/max. thrust)
3
Current command ( 8V/max. current command)
4
5 Speed command ( 8V/max. speed)
Droop pulses ( 10V/100 pulses)
6
7 Droop pulses ( 10V/1000 pulses)
8 Droop pulses ( 10V/10000 pulses)
Droop pulses ( 10V/100000 pulses)
9
Bus voltage ( 8V/400V)
D
Analog monitor 1 (MO1) output axis selection
0: A-axis
1: B-axis
Analog monitor 2 (MO2) output selection
The setting details are the same as analog monitor 1 output.
For the setting details, refer to parameter No.PC09.
Analog monitor 2 (MO2) output axis selection
The setting details are the same as analog monitor 1 output.
For the setting details, refer to parameter No.PC09.
Item
13 - 47
Factory
Setting Unit
setting
Each 0000h
axis
Each 50 mm/s
axis
Common 0000h
Common 0001h
0000h
Setting
range
Refer to
name
and
function
column.
0
to
10000
Refer to
name
and
function
column.
Refer to
name
and
function
column.