Mitsubishi Electric MELSERVO-J3W Series Instruction Manual page 330

13. USING A LINEAR SERVO MOTOR
Alarm No.96
Alarm description
Display Name
96.1 INP error at
home positioning
96.2 Command input
error at home
positioning
Alarm No.E0
Warning description
Display Name
E0.1 Excessive
regeneration
warning
Alarm No.E1
Alarm description
Display Name
E1.1 Thermal overload
warning 1 during
operation
E1.2 Thermal overload
warning 2 during
operation
E1.3 Thermal overload
warning 3 during
operation
E1.4 Thermal overload
warning 4 during
operation
E1.5 Thermal overload
warning 1 during
a stop
E1.6 Thermal overload
warning 2 during
a stop
E1.7 Thermal overload
warning 3 during
a stop
E1.8 Thermal overload
warning 4 during
a stop
Name: Home position setting warning
Home positioning cannot be made.
Cause
Same as for the rotary servo motor.
Refer to section 8.4.
Name: Excessive regeneration warning
There is a possibility that regenerative power may exceed permissible regenerative power of built-in
regenerative resistor or regenerative option.
Cause
Same as for the rotary servo motor.
Refer to section 8.4.
Name: Overload warning 1
There is a possibility that overload alarm (50. , 51. ) may occur.
Cause
Same as for the rotary servo motor.
Refer to section 8.4.
Stop method: Axes can operate (detected by
Checkpoint
Stop method: Axes can operate (warning
Checkpoint
Stop method: Axes can operate (detected at
Checkpoint
13 - 81
the corresponding axis).
Finding Action
detected at both axes)
Finding Action
the corresponding axis)
Finding Action