Mitsubishi Electric MELSERVO-J3W Series Instruction Manual page 126

6. GENERAL GAIN ADJUSTMENT
(2) For position control
(a) Parameters
The following parameters are used for gain adjustment.
Parameter No.
PB06
PB07
PB08
PB09
PB10
(b) Adjustment procedure
Step
1 Brief-adjust with auto tuning. Refer to section 6.2.3.
2 Change the setting of auto tuning to the manual mode (Parameter No.PA08:
0003).
3 Set an estimated value to the load to motor inertia moment ratio. (If the
estimate value with auto tuning is correct, setting change is not required.)
4 Set a slightly smaller value to the model loop gain and the position loop gain.
Set a slightly larger value to the speed integral compensation.
5 Increase the speed loop gain within the vibration- and unusual noise-free
range, and return slightly if vibration takes place.
6 Decrease the speed integral compensation within the vibration-free range,
and return slightly if vibration takes place.
7 Increase the position loop gain, and return slightly if vibration takes place.
8 Increase the model loop gain, and return slightly if overshooting takes place.
9 If the gains cannot be increased due to mechanical system resonance or the
like and the desired response cannot be achieved, response may be
increased by suppressing resonance with machine resonance suppression
filter and then executing steps 3 to 5.
10 While checking the settling characteristic and rotational status, fine-adjust
each gain.
Abbreviation
GD2 Load to motor inertia moment ratio
PG1 Model loop gain
PG2 Position loop gain
VG2 Speed loop gain
VIC Speed integral compensation
Operation
Increase the speed loop gain.
Decrease the time constant of the speed
integral compensation.
Increase the position loop gain.
Increase the position loop gain.
Suppression of machine resonance.
Refer to section 7.2.
Fine adjustment
6 - 9
Name
Description