Mitsubishi Electric MELSERVO-J3W Series Instruction Manual page 375

14. USING A DIRECT DRIVE MOTOR
Note 1. Wait for about 30 minutes as cooling time after removing the cause of occurrence, then deactivate the
Display Name
46 Direct drive motor overheat
47 Cooling fan error
50 Overload 1
51 Overload 2
52 Error excessive
8A USB communication time-out error
8E USB communication error
888 Watchdog
91 Main circuit device overheat warning
92 Battery cable disconnection warning
96 Home position setting warning
9F Battery warning
E0 Excessive regeneration warning
E1 Overload warning 1
E2 Direct drive motor overheat warning
E3 Absolute position counter warning
E4 Parameter warning
E6 Servo forced stop warning
E7 Controller forced stop warning
E8 Cooling fan speed reduction warning
E9 Main circuit off warning
EB The other axis error warning
EC Overload warning 2
ED Output watt excess warning
alarm.
2. In some controller communication status, the alarm factor may not be removed.
3. Indicates detected axis of alarm/warning.
Each: Alarm/warning will be detected for each axis.
Common: Alarm/warning will be detected as a common axis.
4. When an alarm/warning occurs, following axis will stop.
Each axis: Only detected axis will stop.
All axes: All axes will stop.
5. To cancel it, set parameter No.PS04 to "1
Alarm deactivation
Power off
to on
(Note 1) (Note 1)
(Note 1) (Note 1)
(Note 1) (Note 1)
".
14 - 42
Detection
system
Error
CPU reset
(Note 3)
reset
(Note 1)
Each
Common
(Note 1)
Each
(Note 1)
Each
Each
Common
Common
Common
Common
Each
Each
Each
Common
Each
Each
Each
Each
Common
Common
Common
Common
Each
Each
Each
Stop
system
(Note 4)
Each
All axes
Each
Each
Each
All axes
All axes
All axes
All axes
All axes
All axes
All axes