Mitsubishi Electric MELSERVO-J3W Series Instruction Manual page 57

General-purpose ac servo, sscnet interface 2-axis ac servo amplifier
Hide thumbs Also See for MELSERVO-J3W Series:
Table of Contents

Advertisement

3. SIGNALS AND WIRING
3.9 SSCNET cable connection
(1) SSCNET cable connection
For CN1A connector, connect SSCNET cable connected to controller in host side or servo amplifier.
For CN1B connector, connect SSCNET cable connected to servo amplifier in lower side.
For CN1B connector of the final axis, put a cap came with servo amplifier.
Controller
(2) How to connect/disconnect cable.
(a) Mounting
1) For SSCNET cable in the shipping status, the tube for protect optical cord end is put on the end of
connector. Remove this tube.
2) Remove the CN1A CN1B connector cap of servo amplifier.
POINT
Do not see directly the light generated from CN1A CN1B connector of servo
amplifier or the end of SSCNET cable.
When the light gets into eye, may feel something is wrong for eye.
Servo amplifier
SSCNET
cable
POINT
CN1A CN1B connector is put a cap to protect light device inside connector from
dust.
For this reason, do not remove a cap until just before mounting SSCNET cable.
Then, when removing SSCNET cable, make sure to put a cap.
Keep the cap for CN1A CN1B connector and the tube for protecting optical cord
end of SSCNET cable in a plastic bag with a zipper of SSCNET cable to
prevent them from becoming dirty.
When asking repair of servo amplifier for some troubles, make sure to put a cap on
CN1A CN1B connector.
When the connector is not put a cap, the light device may be damaged at the
transit.
In this case, exchange and repair of light device is required.
Servo amplifier
SSCNET
cable
CN1A
CN1B
3 - 24
Final axis servo amplifier
SSCNET
cable
CN1A
CN1B
CN1A
Cap
CN1B

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents