Mitsubishi Electric MELSERVO-J3W Series Instruction Manual page 441

15. MR-J3W-0303BN6 SERVO AMPLIFIER
15.5 Parameters
15.5.1 Basic setting parameters (No.PA
No. Symbol
PA19 *BLK Parameter writing inhibit
In the factory setting, this servo amplifier allows changes to the basic setting parameter, the gain/filter parameter
and the extension setting parameter settings. With the setting of parameter No.PA19, write can be disabled to
prevent accidental changes.
The following table indicates the parameters which are enabled for reference and write by the setting of
parameter No.PA19. Operation can be performed for the parameters marked
Setting
PA19 setting
operation
0000h Reference
Writing
000Bh Reference
(default value)
Writing
000Ch Reference
Writing
000Dh Reference
Writing
000Eh Reference
Writing
00ABh Reference
Writing
100Bh Reference
Writing
100Ch Reference
Writing
100Dh Reference
Writing
100Eh Reference
Writing
10ABh Reference
Writing
Note. When using a rotary servo motor, you do not use the parameter.
POINT
This section explains parameters only for MR-J3W-0303BN6. Refer to chapter 5 for
the other parameters.
)
Parameter
Name
POINT
To enable the parameter value, cycle the power or reset the controller after setting
the parameter.
Basic setting Gain/filter
parameters parameters
No.PA No.PB
PA19 only
PA19 only
PA19 only
PA19 only
PA19 only
Extension
I/O setting
setting
parameters
parameters
No.PD parameters
No.PC
15 - 36
Each/ Default
common value
Each 000Bh
.
(Note)
Option Manufacturer
Special
setting
setting
parameters parameters
No.Po No.PE
No.PS
Setting
Unit
range
Refer to
the text.
Other
setting function
parameters
No.PF