Mitsubishi Electric MELSERVO-J3W Series Instruction Manual page 219

11. OPTIONS AND AUXILIARY EQUIPMENT
(3) MR Configurator
MR Configurator MRZJW3-SETUP221E supports MR-J3W-B. The following table shows notes for using
MR-J3W-B with MR Configurator.
(a) Specification and setting
Item
System setting
Station No. selection
USB communication
Via EzSocket
(b) Selecting an axis to communicate
Follow the following procedure to switch the communicating axis.
Step 1: Display the System Settings.
Step 2: Press down "Ctrl" "Alt" "Shift" "F5" simultaneously to activate the station selection.
Mode
Select "MR-J3-B."
A-axis Servo amplifier: Set parameter No.PC15 to "0 (initial setting)".
MR Configurator: Select the station number "0".
With the software whose version is C3 or later, this setting is not required.
B-axis Servo amplifier: Set parameter No.PC15 to "1".
MR Configurator: Select the station number "1".
With the software whose version is C3 or later, this setting is not required.
All monitor Same display as MR-J3-B
graph Three channels for each of two axes can be measured. (Set measuring axes
using parameters.)
Test operation One axis only (cannot use two axes simultaneously.)
Machine analyzer To vibrate one axis (cannot use two axes simultaneously.)
I/O interface Only the information on the communicating axis. Pin numbers of MR-J3-B are
the pin numbers.
Tuning Vibration suppression control tuning and machine resonance filter tuning are not
available.
Multiple axis monitor Not supported
Multiple axis graph Three channels for each of two axes can be measured. (Set measuring axes
using parameters.)
Specification/setting
11 - 34