Power Supply Cable Wiring Diagrams - Mitsubishi Electric MELSERVO-J3W Series Instruction Manual

13. USING A LINEAR SERVO MOTOR

13.2.2 Power supply cable wiring diagrams

Use the wires and connectors shown in the following figure. For the wires used for wiring, refer to section 11.5.
Servo amplifier Branch cable (Note 3)
CN2A/CN2B
5
THM1
6
THM2
CNP3A/
CNP3B
U U
V V
W W
Note 1. The signal name (U, V, W, E, G1, G2) is attached on leads.
The following shows the lead length.
LM-H2: 0.4m
LM-U2: 0.4m
LM-K2: 0.5m
2. No polarity for the thermistors (G1 and G2)
3. Make the branch cable using the MR-J3THMCN2 connector set.
30m or less
Round crimping terminal
13 - 6
(Note 1)
Lead supplied with
linear servo motor
Linear servo motor
G1 (Black)
(Note 2)
G2 (Black)
Primary
U (Black)
V (Black)
W (Black)
E (Green/yellow)
side
(coil)