I/O Setting Parameters (No.pd ) - Mitsubishi Electric MELSERVO-J3W Series Instruction Manual

5. PARAMETERS
5.4 I/O setting parameters (No.PD
5.4.1 Parameter list
No. Symbol
PD01 This parameter is not used. Do not change the value.
PD02
PD03
PD04
PD05
PD06
PD07 *DO1 Output signal device selection 1 (CN3-12 for A-axis and CN3-25 for B-axis)
PD08 This parameter is not used. Do not change the value.
PD09 *DO3 Output signal device selection 3 (CN3-11 for A-axis and CN3-24 for B-axis)
PD10 This parameter is not used. Do not change the value.
PD11
PD12
PD13
PD14 *DOP3 Function selection D-3
PD15 This parameter is not used. Do not change the value.
PD16
PD17
PD18
PD19
PD20
PD21
PD22
PD23
PD24
PD25
PD26
PD27
PD28
PD29
PD30
PD31
PD32
Note 1. Each axis: Set a value for each of the A-axis and the B-axis.
Common: Common parameters for the A-axis and the B-axis. Set same values for the A-axis and the B-axis. If different values are
set, the last set value becomes valid.
2. Valid for the A-axis and the B-axis.
)
POINT
The parameter whose symbol preceded by * can be validated with the following
conditions.
* : Turn off the power and then on again, or reset the controller after setting the
parameter.
Name
5 - 24
Factory
Setting
setting Unit
(Note 1)
(Note 2)
0000h
0000h
0020h
0021h
0022h
0000h
Each axis 0005h
0004h
Each axis 0003h
0000h
0004h
0000h
0000h
Each axis 0000h
0000h
0000h
0000h
0000h
0000h
0000h
0
0
0
0
0000h
0000h
0000h
0000h
0000h
0000h
0000h
0000h