Mitsubishi Electric MELSERVO-J3W Series Instruction Manual page 89

5. PARAMETERS
5.1.1 Parameter list
No. Symbol
PA01 **STY Control mode
PA02 **REG Regenerative option
PA03 *ABS Absolute position detection system
PA04 *AOP1 Function selection A-1
PA05 This parameter is not used. Do not change the value.
PA06
PA07
PA08 ATU Auto tuning mode
PA09 RSP Auto tuning response
PA10 INP In-position range
PA11 This parameter is not used. Do not change the value.
PA12
PA13
PA14 *POL Rotation direction selection
PA15 *ENR Encoder output pulses
PA16 *ENR2 Encoder output pulses 2
PA17 This parameter is not used. Do not change the value.
PA18
PA19 *BLK Parameter write inhibit
Note 1. Each axis: Set a value for each of the A-axis and the B-axis.
Common: Common parameters for the A-axis and the B-axis. Set same values for the A-axis and the B-axis. If different values are
set, the last set value becomes valid.
2. Valid for the A-axis and the B-axis.
Name
5 - 2
Factory
Setting
setting Unit
(Note 1)
(Note 2)
Each axis 0000h
Common 0000h
Each axis 0000h
Common 0000h
0
1
1
Each axis 0001h
Each axis 12
Each axis 100 pulse
1000.0
1000.0
0000h
Each axis 0
Each axis 4000 pulse/rev
Each axis 0
0000h
0000h
Each axis 000Bh