Mitsubishi Electric MELSERVO-J3W Series Instruction Manual page 88

5. PARAMETERS
5. PARAMETERS
CAUTION
In this servo amplifier, the parameters are classified into the following groups on a function basis.
Parameter group
Basic setting parameters
(No.PA )
Gain/filter parameters
(No.PB )
Extension setting parameters
(No.PC )
I/O setting parameters
(No.PD )
Extension control parameters
(No.PE )
Option setting parameters
(No.Po )
Mainly setting the basic setting parameters (No.PA
introduction.
5.1 Basic setting parameters (No.PA
Never adjust or change the parameter values extremely as it will make operation
instable.
When the fixed values are indicated for any digits of a parameter, never change the
values of the digits.
POINT
When the servo amplifier is connected with the servo system controller, the
parameters are set to the values of the servo system controller.
Setting may not be made to some parameters and ranges depending on the model
or software version of the servo system controller. For details, refer to the servo
system controller user's manual.
Make basic setting with these parameters. Generally, the operation is possible only with these
parameter settings.
Use these parameters when making gain adjustment manually.
When changing settings such as analog monitor output signal or encoder electromagnetic brake
sequence output, use these parameters.
Use these parameters when changing the I/O signals of the servo amplifier.
Use these parameters when selecting a function in the fully closed loop system.
These parameters are dedicated to MR-J3W.
)
POINT
The parameter whose symbol preceded by * can be validated with the following
conditions.
* : Turn off the power and then on again, or reset the controller after setting the
parameter.
**: Turn off the power and then on again after setting the parameter.
Main description
) allows the setting of the basic parameters at the time of
5 - 1