Mitsubishi Electric MELSERVO-J3W Series Instruction Manual page 486

APPENDIX
App. 4 COMPLIANCE WITH UL/CSA STANDARD
This servo amplifier complies with UL 508C and CSA C22.2 No.14 standard.
Refer to section 1.3 (2) for the servo amplifier model names described in the tables and figures.
(1) Servo amplifiers and servo motors used
Use the servo amplifiers and servo motors which standard product.
(2) Installation
The MR-J3W series have been approved as the products which have been installed in the electrical
enclosure.
The minimum enclosure size is based on 150
And also, design the enclosure so that the ambient temperature in the enclosure is 55
refer to the spec manual.
The Servo amplifier must be installed in the metal cabinet (control box).
MR-J3W-
Servo motor
0303BN6
A-axis/B-axis
HG-AK0136
HG-AK0236
HG-AK0336
HF-MP053
HF-MP13
HF-MP23
HF-MP43
HF-MP73
HF-KP053
HF-KP13
HF-KP23
HF-KP43
HF-KP73
HF-SP51
HF-SP81
HF-SP52
HF-SP102
HC-LP52
HC-LP102
HC-UP72
HF-JP53
HF-JP73
HF-JP103
Note 1. When using this servo amplifier with software version B2 or below, it is required to set
parameter No.Po04 to "
setting the parameter is not required.
2. The servo motor is available for servo amplifiers with software version B3 or above.
3. For this combination, the maximum torque of the HF-JP53 servo motor will be 400
torque.
App. - 9
Servo amplifier
MR-J3W-22B MR-J3W-44B
A-axis/B-axis A-axis/B-axis
1 ". For the servo amplier with software version B3 or above,
of each MR-J3W combination.
MR-J3W-77B
A-axis/B-axis
(Note1)
(Note1)
(Note1)
(Note1)
(Note1)
(Note1)
(Note1)
(Note1)
(Note1)
(Note1)
(Note2)
(Note2)
(131 ) or less,
MR-J3W-
1010B
A-axis/B-axis
(Note1)
(Note1)
(Note2, 3)
(Note2)
(Note2)
of rated