Mitsubishi Electric MELSERVO-J3W Series Instruction Manual page 306

General-purpose ac servo, sscnet interface 2-axis ac servo amplifier

Hide thumbs Also See for MELSERVO-J3W Series:

Table of Contents

13. USING A LINEAR SERVO MOTOR

This parameter is not used. Do not change the value.

13.6.7 Option setting parameter

*OOP1 Function selection O-1

Axis selection for graphing analog data (MR Configurator)

Axis selection for graphing digtal data (MR Configurator)

Po04 **OOP2 Function selection O-2

This parameter is not used. Do not change the value.

Note 1. Each axis: Set a value for each of the A-axis and the B-axis.

Common: Common parameters for the A-axis and the B-axis. Set same values for the A-axis and the B-axis. If different values are

set, the last set value becomes valid.

2. Valid for the A-axis and the B-axis.

The parameter whose symbol preceded by * can be validated with the following

* : Turn off the power and then on again, or reset the controller after setting the

**: Turn off the power and then on again after setting the parameter.

Common 0000h

Show Quick Links

Table of Contents