Mitsubishi Electric MELSERVO-J3W Series Instruction Manual page 300

General-purpose ac servo, sscnet interface 2-axis ac servo amplifier

Hide thumbs Also See for MELSERVO-J3W Series:

Table of Contents

13. USING A LINEAR SERVO MOTOR

13.6.5 I/O setting parameters (No.PD

(1) Parameter list

This parameter is not used. Do not change the value.

Input signal automatic ON selection

This parameter is not used. Do not change the value.

Output signal device selection 1 (CN3-12 for A-axis and CN3-25 for B-axis)

This parameter is not used. Do not change the value.

Output signal device selection 3 (CN3-11 for A-axis and CN3-24 for B-axis)

This parameter is not used. Do not change the value.

*DOP3 Function selection D-3

This parameter is not used. Do not change the value.

Note 1. Each axis: Set a value for each of the A-axis and the B-axis.

Common: Common parameters for the A-axis and the B-axis. Set same values for the A-axis and the B-axis. If different values are

set, the last set value becomes valid.

2. Valid for the A-axis and the B-axis.

The parameter whose symbol preceded by * can be validated with the following

* : Turn off the power and then on again, or reset the controller after setting the

Show Quick Links

Table of Contents