Rigol DS7034 User Programming Manual page 198

RIGOL
:TRIGger:RUNT:WLOWer
Syntax :TRIGger:RUNT:WLOWer <width>
:TRIGger:RUNT:WLOWer?
Description Sets or queries the lower limit of the pulse width of Runt trigger. The default unit is s.
Parameter
Name
<width>
Remarks This command is only available when the qualifier is set to GREater or GLESs.

When the qualifier is set to "GLESs", the lower limit of the pulse width must be

smaller than the upper limit of the pulse width.
Return
The query returns the lower limit of the pulse width in scientific notation.
Format
Example :TRIGger:RUNT:WLOWer 0.01
:TRIGger:RUNT:WLOWer?
:TRIGger:RUNT:ALEVel
Syntax :TRIGger:RUNT:ALEVel <level>
:TRIGger:RUNT:ALEVel?
Description Sets or queries the upper limit of the trigger level of Runt trigger. The unit is the same
as that of the current amplitude.
Parameter
Name
<level>
Remarks For VerticalScale, refer to the
the :CHANnel<n>:OFFSet
Return The query returns the upper limit of the trigger level in scientific notation.
Format
Example
:TRIGger:RUNT:ALEVel 0.16
:TRIGger:RUNT:ALEVel?
:TRIGger:RUNT:BLEVel
Syntax :TRIGger:RUNT:BLEVel <level>
:TRIGger:RUNT:BLEVel?
Description Sets or queries the lower limit of the trigger level of Runt trigger. The unit is the same
as that of the current amplitude.
Parameter
Name
<level>
Remarks For VerticalScale, refer to the
the
Return The query returns the lower limit of the trigger level in scientific notation.
Format
Example :TRIGger:RUNT:BLEVel 0.16
:TRIGger:RUNT:BLEVel?
2-184
Type Range
8 ns to 9.9 s
Real
Type Range
Real Lower limit to (5 × VerticalScale - OFFSet)
command.
Type Range
Real (-5 × VerticalScale - OFFSet) to upper limit
:CHANnel<n>:OFFSet
/*Sets the lower limit of the pulse width to 10 ms.*/
/*The query returns 1.000000E-2.*/
:CHANnel<n>:SCALe
/*Sets the upper limit of the trigger level to 160 mV.*/
/*The query returns 1.600000E-1.*/
:CHANnel<n>:SCALe
command.
/*Sets the lower limit of the trigger level to 160 mV.*/
/*The query returns 1.600000E-1.*/
Chapter 2 Command System
Default
8 ns
Default
0 V
command; for OFFSet, refer to
Default
0 V
command; for OFFSet, refer to
MSO7000/DS7000 Programming Guide