Rigol DS7034 User Programming Manual page 27

Chapter 2 Command System
Example :BUS1:PARallel:SLOPe BOTH
:BUS1:PARallel:SLOPe?
:BUS<n>:PARallel:WIDTh
Syntax :BUS<n>:PARallel:WIDTh <wid>
:BUS<n>:PARallel:WIDTh?
Description Sets or queries the data width of the parallel bus, i.g. the number of bits per frame.
Parameter
Name
<n>
<wid>
Remarks After you send this command to set the data width of the bus, send

the
the bit respectively and set the channel source for the bit.
Only when the bus source is set to User, can this command be valid.

Return
The query returns an integer ranging from 0 to 20 (for MSO7000 model) or 0 to 4 (for
Format
DS7000 model).
Example :BUS1:PARallel:WIDTh 16
:BUS1:PARallel:WIDTh?
:BUS<n>:PARallel:BITX
Syntax :BUS<n>:PARallel:BITX <bit>
:BUS<n>:PARallel:BITX?
Description
Sets or queries the data bit that the parallel bus requires to set for the channel source.
Parameter
Name
<n>
<bit>
Remarks The data width is set by the

After selecting the desired bit, send the

set the channel source for the bit.
The data bit should be smaller than or equal to the data width.

Return
The query returns the current data bits in integer. Its unit is Hz.
Format
Example :BUS1:PARallel:BITX 2
:BUS1:PARallel:BITX?
MSO7000/DS7000 Programming Guide
Type Range
Discrete {1|2|3|4}
0 to 20 (for MSO7000 model)
Integer
0 to 4 (for DS7000 model)
:BUS<n>:PARallel:BITX
/*Sets the data width of Parallel decoding to 16.*/
/*The query returns 16.*/
Type Range
Discrete {1|2|3|4}
Integer 0 to (data width - 1)
/*Sets the current bit to 2.*/
/*The query returns 2.*/
/*Sets the Parallel decoding to sample on any edge
of the clock channel.*/
/*The query returns BOTH.*/
and :BUS<n>:PARallel:SOURce
:BUS<n>:PARallel:WIDTh
:BUS<n>:PARallel:SOURce
RIGOL
Default
——
1
command to select
Default
——
0
command.
command to
2-13