[:Source[<N>]] Commands - Rigol DS7034 User Programming Manual

Chapter 2 Command System
[:SOURce[<n>]] Commands
The [:SOURce[<n>]] commands are used to set the relevant parameters of the built-in function/arbitrary
waveform generator. <n> can set to 1 or 2, which indicates the corresponding built-in function/arbitrary
waveform generator channel. When <n> or :SOURce[<n>] is omitted, by default, the operations are
carried out on AWG GI. The commands are only available for the MSO7000 model installed with the
function/arbitrary waveform generator option.
Command List:
[:SOURce[<n>]]:FREQuency[:FIXed]

[:SOURce[<n>]]:PHASe[:ADJust]

[:SOURce[<n>]]:PHASe:INITiate

[:SOURce[<n>]]:FUNCtion[:SHAPe]

[:SOURce[<n>]]:FUNCtion:RAMP:SYMMetry

[:SOURce[<n>]]:VOLTage[:LEVel][:IMMediate][:AMPLitude]

[:SOURce[<n>]]:VOLTage[:LEVel][:IMMediate]:OFFSet

[:SOURce[<n>]]:PULSe:DCYCle

[:SOURce[<n>]]:MOD:TYPE

[:SOURce[<n>]]:MOD:AM[:DEPTh]

[:SOURce[<n>]]:MOD:AM:INTernal:FREQuency

[:SOURce[<n>]]:MOD:FM:INTernal:FREQuency

[:SOURce[<n>]]:MOD:AM:INTernal:FUNCtion

[:SOURce[<n>]]:MOD:FM:INTernal:FUNCtion

[:SOURce[<n>]]:MOD:FM[:DEVIation]

[:SOURce[<n>]]:APPLy?

[:SOURce[<n>]]:APPLy:NOISe

[:SOURce[<n>]]:APPLy:PULSe

[:SOURce[<n>]]:APPLy:RAMP

[:SOURce[<n>]]:APPLy:SINusoid

[:SOURce[<n>]]:APPLy:SQUare

[:SOURce[<n>]]:APPLy:USER

[:SOURce[<n>]]:OUTPut[<n>][:STATe]

[:SOURce[<n>]]:OUTPut[<n>]:IMPedance

MSO7000/DS7000 Programming Guide
RIGOL
2-137