Display Commands; Display:clear; Display:type - Rigol DS7034 User Programming Manual

Chapter 2 Command System

:DISPlay Commands

The :DISPlay commands can be used to set the displayed type of the waveform, persistence time, intensity,
grid type, grid brightness, etc.
Command List:

:DISPlay:CLEar



:DISPlay:TYPE


:DISPlay:GRADing:TIME

:DISPlay:WBRightness

:DISPlay:GRID

:DISPlay:GBRightness

:DISPlay:DATA?

:DISPlay:RULers

:DISPlay:COLor

:DISPlay:CLEar
Syntax :DISPlay:CLEar
Description Clears all the waveforms on the screen.
Remarks If the oscilloscope is in the "RUN" state, new waveforms will continue being

displayed after being cleared.
This command functions the same as the CLEAR key on the front panel. You can

also send the
:DISPlay:TYPE
Syntax :DISPlay:TYPE <type>
:DISPlay:TYPE?
Description Sets or queries the display type of the waveforms on the screen.
Parameter
Name
<type>
Remarks VECTors: The sample points are connected by lines and displayed. In most cases,

this mode can provide the most vivid waveform for you to view the steep edge of
the waveform (such as square waveform)
DOTS: displays the sample points directly. You can directly view each sample point

and use the cursor to measure the X and Y values of the sample point.
Return
The query returns VECT or DOTS.
Format
Example :DISPlay:TYPE DOTS
:DISPlay:TYPE?
MSO7000/DS7000 Programming Guide
:CLEar command to clear all the waveforms on the screen.
Type Range
Discrete {VECTors|DOTS}
/*Selects the dots display mode.*/
/*The query returns DOTS.*/
RIGOL
Default
VECTors
2-65