Bus<N>:Parallel - Rigol DS7034 User Programming Manual

RIGOL
:BUS<n>:PARallel
The :BUS<n>:PARallel commands are used to set relevant parameters for Parallel decoding.
Command List:
:BUS<n>:PARallel:CLK

:BUS<n>:PARallel:SLOPe

:BUS<n>:PARallel:WIDTh

:BUS<n>:PARallel:BITX

:BUS<n>:PARallel:SOURce

:BUS<n>:PARallel:POLarity

:BUS<n>:PARallel:NREJect

:BUS<n>:PARallel:NRTime

:BUS<n>:PARallel:CLK
Syntax :BUS<n>:PARallel:CLK <source>
:BUS<n>:PARallel:CLK?
Description Sets or queries the clock source of the Parallel decoding.
Parameter
Name
<n>
<source>
Return The query returns D0, D1, D2, D3, D4, D5, D6, D7, D8, D9, D10, D11, D12, D13, D14,
Format D15, CHAN1, CHAN2, CHAN3, CHAN4, or OFF.
Example :BUS1:PARallel:CLK D0
:BUS1:PARallel:CLK?
:BUS<n>:PARallel:SLOPe
Syntax :BUS<n>:PARallel:SLOPe <slope>
:BUS<n>:PARallel:SLOPe?
Description Sets or queries the edge type of the clock channel when being sampled by Parallel
decoding on the data channel.
Parameter
Name
<n>
<slope>
Remarks If no clock channel is selected, the instrument will sample when the channel data
jumps during the decoding.
Return
The query returns POS, NEG, or BOTH.
Format
2-12
Type Range
Discrete {1|2|3|4}
{D0|D1|D2|D3|D4|D5|D6|D7|D8|
D9|D10|D11|D12|D13|D14|D15|
Discrete
CHANnel1|CHANnel2|CHANnel3|CHANnel4|
OFF}
/*Sets the clock source of the Parallel decoding to D0.*/
/*The query returns D0.*/
Type Range
Discrete {1|2|3|4}
Discrete {POSitive|NEGative|BOTH}
Chapter 2 Command System
Default
——
OFF
Default
——
POSitive
MSO7000/DS7000 Programming Guide