Adding Power Supplies And Tape Drives; Power Supply; Sl150 Library Rear View - Oracle StorageTek SL150 Installation Manual

Adding Power Supplies and Tape Drives

6
The tape drives and power supplies are located at the back of the library (see
Figure
supplies. You can add tape drives and power supplies as your needs grow.
The power supply and tape drive can be added while the library is powered-on.
However, you must restart the library for it to recognize and account for the tape drive
if the library is not set to address all drive slots.
The instructions in this chapter have you remove the power supply or drive filler and
immediately insert the new power supply or tape drive in the open slot.
Figure 6–1 SL150 Library Rear View
Illustration Legend:
1 - Tape Drive Filler
2 - Power Supply Filler

Power Supply

Two actions are involved to add a power supply (see
1) removal of the power supply filler and 2) installation of the power supply. No tools
are required to perform these tasks.
6–1). Each module in the library has space for two tape drives and two power
Do not operate the library with open tape drive or
Warning:
power supply slots.
Figure 6–2) to a library module:
Adding Power Supplies and Tape Drives 6-1
6