Configuration Procedure With The K7Dd Unit Only; K7Dd Input Setting - Omron K7DD User Manual

2 Procedures

Configuration Procedure with the K7DD Unit Only

(3) K7DD Input Setting

Set the parameters related to Input Setting of K7DD (Initial Setting
Level).
Configuration with Key Operations
Make input settings on the Initial Setting Level.
1.
When you press the Level Key (O) for 3 seconds or more on
the Operation Level, you are moved to the Initial Setting Level.
Refer to
on how to change the setting parameters.
Setting parameter
Wiring state
Current Input
Range
Voltage Input
Range
Feature
Calculation Cycle
2.
When you press the Level Key (O) for 1 second or more on the
Initial Setting Level, you are moved to the Monitoring Level after
software reset.
2 - 10
6-6 Initial Setting Level (LVL
11-seg Setting range
Set the connection state of the
wrng
monitoring target.
0: 3P3W2M
1: 3P4W
2: Single-phase current
Set the current input range
i-iN
according to the CT to use.
5 A, 25 A, 100 A, 200 A, 400 A
Set the voltage input range
v-iN
according to the rated voltage of the
device.
150 V, 300 V, 600 V
Sets the period to be recorded as
fcap
normal data during teaching. Up to
100 seconds can be set in 50 ms
increments.
Setting range: 1 to 2000
(Unit: 50 ms/sec)
Refer to
fcap
Cycle (P.6-22) in
Setting Level (LVL 0)".
) (P.6-20) for details
0
Setting
value
0
5a
150v
1
Feature Calculation
"6-6 Initial
Power Line Data Generator User's Manual (N233)
Power ON
Monitoring Level
( O ) At least 1 s ( O ) At least 3 s
Initial Setting Level
Under Measurement
Operation
Measurement Stop
(Operation Stopped)