Cannot Connect The Development Pc And The Controller Using The Usb Cable; Confirmation Using Windows Device Manager - Epson RC180 Manual

8.2 Cannot Connect the Development PC and the Controller
using the USB cable
■ Do not connect the USB cable to a PC or a Controller without installing Program
Development Software EPSON RC+ 5.0 to the PC.
You must install EPSON RC+ 5.0 to control the Controller.
If the USB cable is connected to a PC or a Controller without installing Program
CAUTION
Development Software EPSON RC+ 5.0, the [Add New Hardware] wizard
appears. Click the <Cancel> button to close the [Add New Hardware] wizard.
If the following error message appears when connecting the development PC and
Controller with the USB cable and connecting the Controller to EPSON RC+ 5.0,
Windows may not recognize the Controller properly. Refer to 8.2.1 Confirmation Using
Windows Device Manager to check the connection of the Controller.

8.2.1 Confirmation Using Windows Device Manager

(1) Make sure that the development PC and the Controller is connected to the USB cable.
NOTE

(2) Click Windows-[Control Panel]-<Performance and Maintenance>.
RC180 Rev.17
When checking the Controller connection using the Windows device manager, the
development PC and the Controller must be connected with the USB cable.
Maintenance 8. Trouble Shooting
243