Epson RC180 Manual page 209

No. Message
Windows Communication
2471
Invalid answer.
Windows Communication
2472
Already initialized.
2473 Windows Communication Error. Busy.
Windows Communication Error. No
2474
request.
Windows Communication Error. Data
2475
buffer overflow.
Windows Communication
2476
Failed to wait for event.
Windows Communication
2477
Invalid folder.
Windows Communication
2478
Invalid error code.
Specified event condition for Wait is
2500
beyond the maximum count.
Specified bit number in the Ctr
2501 function was not setup with a CTReset
statement.
Task number is beyond the maximum
2502
count to execute.
Cannot execute Xqt when the specified
2503
task number is already executing.
Task failure. Specified manipulator is
2504
already executing a parallel process.
Not enough data for Input statement
2505
variable assignment.
Specified variable
2506 statement is beyond the maximum
count.
All counters are in use and cannot
2507
setup a new counter with CTReset.
OnErr failure. Failed to process the
2508
OnErr statement.
OnErr failure. Failed to process the
2509
OnErr statement.
2510 Specified I/O label is not defined.
SyncUnlock statement is used without
2511 executing a
statement. Review the program.
SyncLock statement
2512
executed.
2513 Specified point label is not defined.
Failed to obtain the motor on time of
2514
the robot.
Failed to configure the date or the
2515
time.
RC180 Rev.17
Error. Reboot the Controller.
Rebuild the project.
Error.
Reboot the Controller.
Reboot the Controller.
Rebuild the project.
Reboot the Controller.
Rebuild the project.
Reduce the data volume.
Review the program.
Error.
Reboot the Controller.
Error.
Make sure the specified folder is correct.
Error.
Rebuild the project.
The
conditions is 8. Review the program.
Review the program.
The available number of the tasks that
can be executed simultaneously is 16.
Review the program.
Review the program.
Rebuild the project.
Check the content of communication
data. Review the program.
for the Input For OP, only one variable can be
specified. For other devices, up to 32
variables can be specified.
The available number of the counters
that can be set simultaneously is 16.
Review the program.
Rebuild the project.
Rebuild the project.
The specified I/O label is not registered.
Check the I/O label file.
previous SyncLock Review the program.
The SyncLock statement cannot be
was already
executed for the second time in a row.
Review the program.
The
registered. Check the point file.
Reboot the controller.
Check whether a date and time is set
correctly.
Maintenance 8. Trouble Shooting
Remedy
maximum number of
specified point label is
Note 1
event
The specified
bit number
The specified
task number
Signal number
Signal number
not
Note 2
197