Restore From Teach Pendant (Option) - Epson RC180 Manual

Maintenance 4. Backup and Restore
4.4.2 Restore from Teach Pendant TP1 (Option)
■ Make sure that the data used for restore was saved previously for same
Controller.
■ Do not edit the backup files. Otherwise, operation of the robot system after data
CAUTION
restoration to the Controller is not assured.
Restores system files backed up in USB memory to the Controller. (Only TP1. TP2
does not support this function.)
(1) Insert the USB memory into the Controller.
(2) In the [Program Mode] screen, move the cursor to [7 System Restore...], and press
(3)
(4)
(5)
132
the <OK> key.
The following screen appears.
When you restore the robot name, serial number, and the calibration data with the basic
Controller settings, move the cursor to [Robot name, serial #, calibration] and press the
<→> key.
When you restore the project with the basic Controller settings, move the cursor to
[Project] and press the <→> key.
Press the <OK> key
The following screen appears. Press the <OK> key.
RC180 Rev.17