Epson RC180 Manual page 188

Maintenance 8. Trouble Shooting
No. Message
MCD failure. Failed to open the MCD
1160
file.
MCD failure. Failed to read the MCD
1161
file.
MCD failure. Failed to save the MCD
1163
file.
MPD failure. Failed to open the MPD
1165
file.
MPD failure. Failed to read the MPD
1166
file.
MPD failure. Failed to save the MPD
1168
file.
MPL failure. Failed to open the MPL
1170
file.
PRM failure. Failed to replace the
1181
PRM file.
File failure. Failed to open the backup
1185
information file.
File failure. Failed to read the backup
1186
information file.
File failure. Failed to write the backup
1187
information file.
File failure. Failed to save the backup
1188
information file.
The backup data was created by an old
1189
version.
The backup data was created by a
1190
newer version.
1191 There is no project in the backup data.
File failure. Failed to map the
1195
health history.
File failure. Failed to open the
1196
health history file.
File failure. Failed to write the
1197
health history file.
Compile failure.
1200
Check the compile message.
Link failure.
1201
Check the link message.
1500 Communication error.
1501 Command did not complete in time.
Communication
1502 between PC and Controller.
Re-establish communication.
1503 Disconnection while executing a task.
1510 Out of IP Address range.
176
Restore the controller configuration.
Restore the controller configuration.
Restore the controller configuration.
1. Reboot the controller.
2. Reinstall the firmware.
1. Reboot the controller.
2. Reconfigure the robot.
Cannot
configuration in the specified procedure
for using old backup data.
backup data.
Reboot the controller.
Reboot the controller.
Reboot the controller.
This error occurs during compilation
from TP.
occurred.
This error occurs during compilation
from TP.
occurred.
Execute the command again after a
while. Check the connection between
the PC and controller.
disconnection
Check the connection between the PC
and controller.
Check the connection between the
console device and controller.
Check the IP address setting of the
controller.
Remedy
restore the controller
Check the
Correct where the error
Correct where the error
Note 1 Note 2
- -
- -
- -
RC180 Rev.17