Disconnection Of Development Pc And Controller - Epson RC180 Manual

Robot controller
Hide thumbs Also See for RC180:
Table of Contents

Advertisement

(7) After the development PC and the Controller connection has completed, "Connected"
The connection between the development PC and the Controller is completed. Now the
robot system can be used from EPSON RC+ 5.0.

5.4 Disconnection of Development PC and Controller

Disconnection of the development PC and the Controller communication.
(1) Select the EPSON RC+ 5.0 menu-[Setup]-[PC to Controller Communications] to
(2) Click the <Disconnect> button.
NOTE
If the USB cable is removed when the Controller and the development PC are connected,
the Robot will stop. Be sure to click the <Disconnect> button in the [PC to Controller
Communications] dialog before USB cable is removed.
RC180 Rev.17
Setup & Operation 5. Development PC Connection Port
is displayed at [Connection status]. Make sure that "Connected" is displayed and
click the <Close> button to close the [PC to Controller Communications] dialog.
display the [PC to Controller Communications] dialog.
Communication between the Controller and the development PC is disconnected and
the USB cable can be removed.
39

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents