Cable Connection; Typical Cable Connection - Epson RC180 Manual

3.4 Cable Connection

■ Make sure that the power to the Controller is turned OFF and the power plug is
disconnected before connecting or disconnecting any cables. Connecting or
disconnecting any cables with the power ON is extremely hazardous and may
result in electric shock and malfunction of the Controller.
■ Be sure to connect the cables properly. Do not allow unnecessary strain on the
cables. (Do not put heavy objects on the cables. Do not bend or pull the cables
WARNING
forcibly.) The unnecessary strain on the cables may result in damage to the
cables, disconnection, and/or contact failure. Damaged cables, disconnection,
or contact failure is extremely hazardous and may result in electric shock and/or
improper function of the system.
■ The serial number of the Manipulator that should be connected is indicated on the
Connection Check Label on the Controller.
Manipulator correctly.
Manipulator may cause not only improper function of the robot system but also
safety problems.
CAUTION
■ Before connecting the connector, make sure that the pins are not bent.
Connecting with the pins bent may damage the connector and result in
malfunction of the robot system.

3.4.1 Typical Cable Connection

RC180 Rev.17
Improper connection between the Controller and the
Disconnectable connector
Cable attached at delivery
Cable prepared by users
(1) AC Power Terminal Block
(2) M/C Power Cable
(3) M/C Signal Cable
(4) EMERGENCY
(5) PC for Development
Controller
(6) USB Memory
(7) LAN (Ethernet Communication)
(8) I/O Connector
(9) TP Cable B
*1
(10) OP Cable
Option Unit
Setup & Operation 3. Installation
Connect the Controller and the
200-240VAC
Manipulator
Emergency Stop
Safety Door, etc.
PC for Development
Connect by (5) or (7)
Input/Output Device
Operator
(9) TP Cable A
Panel
FieldBus
Expansion I/O
RS-232C
Teach
Pendant
Teach
Pendant
27