Epson RC180 Manual page 249

GUI Builder
No. Message
Cannot execute
7600
statement from the command window.
7602 GSet parameter is too long.
7603 Too many parameters for GGet.
Not enough data for GGet statement
7604
variable assignment.
The event task cannot be executed.
7610 System in
EventTaskType is Normal.
The event task cannot be executed.
7611 Safeguard is open and EventTaskType
is Normal.
The event task cannot be executed.
7612 Estop is active and EventTaskType is
not NoEmgAbort.
The event task cannot be executed.
7613 System in
EventTaskType is not NoEmgAbort.
7650 Invalid property.
7651 Invalid form.
7652 Invalid control.
7653 The specified form is already open.
7654 Event function does not exist.
7655 The item does not exist.
7656 Invalid property value.
MDL failure.
7847
Failed to open the MDL file.
MDL failure.
7848
Failed to read the MDL file.
RC180 Rev.17
a GUI Builder GUI Builder commands are only available in
the program.
Correct the parameter to the proper length.
Check the number of parameters.
Specify the variable.
The system can be operated by changing
pause state and
EventTaskType to "NoPause"
The system can be operated by changing
EventTaskType to "NoEmgAbort"
The system can be operated by changing
EventTaskType to "NoEmgAbort"
The system can be operated by changing
error state and
EventTaskType to "NoEmgAbort"
Specify the valid property.
Specify the valid form.
Specify the valid control.
Modify the program to avoid double launch.
Check the function name set for the event.
Specify the valid item.
Check the property value and specify the valid
value.
Reboot the controller.
Reinstall the firmware.
Reboot the controller.
Reinstall the latest firmware version.
Maintenance 8. Trouble Shooting
Remedy Note 1 Note 2
- -
- -
237