Epson RC180 Manual page 254

Maintenance 8. Trouble Shooting
EPSON RC+
No.
7713 Option not enabled.
7714 File not found.
10000 Command aborted by user
10001 Command timeout.
10002 Bad point file line syntax
10003 Project could not be built.
10004 Cannot initialize Spel class instance.
10005 Cannot initialize parser.
10006 Cannot initialize wbproxy.
10007 Project does not exist.
10008 No project specified.
10009 Cannot open file.
10010 Cannot create file.
10011 File not found
10012 Option not enabled
Cannot execute LoadPoints with Robot
10013
Manager open.
Project cannot be locked. It is being used
10014
by another session.
10015 Project could not be synchronized.
10016 Drive not ready
10017 Invalid IP address
10018 Invalid IP mask
10019 Invalid IP gateway
IP address or gateway cannot be the subnet
10020
address
IP address or gateway cannot be the
10021
broadcast address
10022 Invalid DNS address
Commands cannot be executed because
10023
the project build is not complete.
10024 Invalid task name.
10025 Trial runtime expired.
10100 Command already in cycle.
10101 Command aborted by user.
242
Message Remedy
Check whether the project name
and the path are correct.
Specify the project.
Check whether the project name
and the path are correct.
Check whether the project name
and the path are correct.
Close the robot manager and
execute.
Terminate other applications.
Check whether the
designation is correct.
Check the IP address.
Check the IP mask.
Check the IP gateway.
Check the IP address.
Check the IP address.
Check the DNS.
Execute after the project build is
completed.
Check the task name.
Note 1
drive
RC180 Rev.17
Note 2