Digital Operator And; Digital Operator And; Removing/Reattaching The Digital Operator; Removing/Reattaching The - YASKAWA AC Drive-A1000 Technical Manual

3.6 Digital Operator and Front Cover
3.6 Digital Operator and Front Cover
Detach the digital operator from the drive for remote operation or when opening the front cover to install an option card.
NOTICE: Be sure to remove the digital operator prior to opening or reattaching the front cover. Leaving the digital operator plugged into the
drive when removing the front cover can result in erroneous operation caused by a poor connection. Firmly fasten the front cover back into
place before reattaching the digital operator.
u

Removing/Reattaching the Digital Operator

n Removing the Digital Operator
While pressing on the tab located on the right side of the digital operator, pull the digital operator forward to remove it from
the drive.
n Reattaching the Digital Operator
Insert the digital operator into the opening in the top cover while aligning it with the notches on the left side of the opening.
Next, press gently on the right side of the operator until it clicks into place.
u
Removing/Reattaching the Front Cover
n Removing the Front Cover
5A0003 to 5A0032
After removing the terminal cover and the digital operator, loosen the screw that affixes the front cover (models 5A0022 and
5A0027 do not use a screw to affix the front cover) . Pinch in on the tabs found on each side of the front cover, then pull
forward to remove it from the drive.
n Reattaching the Front Cover
Reverse the instructions given in above to reattach the front cover. Pinch inwards on the tabs found on each side of the front
cover while guiding it back into the drive. Make sure it clicks firmly into place.
56
Figure 3.7 Removing the Digital Operator
Figure 3.8 Reattaching the Digital Operator
Figure 3.9 Remove the Front Cover
YASKAWA ELECTRIC SIEP C710616 31B YASKAWA AC Drive – A1000 Technical Manual