Table 40: Wbm Page, "Port Settings" - "General Settings" Tab - WAGO 852-1305 Manual

WAGO-ETHERNET-Zubehör 852
852-1305 8/4-Port 100BASE-T/1000BASE-SX/LX
Table 40: WBM Page, "Port Settings" – "General Settings" Tab
Port Settings
Parameters
Port
State
Speed/Duplex
Flow Control
Port State
Parameters
Port
State
Speed/Duplex
Flow Control
Link State
Manual
1.1.0
Configuring in the Web-Based Management System (WBM)
Default
From: 1
to: 1
Disable
Enable
Auto
10 Mbit/s /
Full Duplex
10 Mbit/s /
Half Duplex
100 Mbit/s /
Full Duplex
100 Mbit/s /
Half Duplex
1000 Mbit/s /
Full Duplex
Off
On
Default
1 ... 10
Description
Select a port or port range that you want to
configure.
Select a port or port range that you want to
configure.
Select "Disable" to disable the port.
Select "Enable" to enable the port.
Select the speed and duplex mode of the port.
Select "Off" to disable access to the port's buffer
resources and to interrupt operation of the switches
in the network.
Select "On" to maintain access to the port's buffer
resources and to ensure lossless operation of the
switches in the network.
Description
This column displays the port numbers.
This column displays if the port is enabled or
disabled.
This column displays the configured speed
(10 Mbit/s, 100 Mbit/s or 1000 Mbit/s) and duplex
mode (full or half-duplex) for a port.
This column displays whether the port's "Flow
Control" is set to "On" or "Off".
This column displays the link status of a port. If the
port is up, the speed, duplex mode and "Flow
Control" settings are displayed. "Link Up" displays
that the port is either disabled or no device is
connected.
135