Table 138: Cli "Loop Detection" Configuration; Loop Detection - WAGO 852-1305 Manual

278 Appendix

10.3.3.16 Loop Detection

Table 138: CLI "Loop Detection" Configuration

Node
enable
configure
configure
configure
interface
interface
interface
interface
Example
L2SWITCH(config)#loop-detection enable
L2SWITCH(config)#interface 1/0/1
L2SWITCH(config-if)#loop-detection enable
L2SWITCH(config-if)#loop-detection recovery enable
L2SWITCH(config-if)#loop-detection recovery time 10
Command
show loop-detection
loop-detection (disable |
enable)
loop-detection address
MACADDR
no loop-detection address
loop-detection (disable |
enable)
no shutdown
loop-detection recovery
(disable | enable)
loop-detection recovery
time VALUE
WAGO-ETHERNET-Zubehör 852
852-1305 8/4-Port 100BASE-T/1000BASE-SX/LX
Description
This command displays the current configuration for
"Loop Detection".
This command disables / enables "Loop Detection"
on the switch.
This command configures the target MAC address
for special "Loop Detection" packets.
This command resets the target MAC address to the
default setting (00:0b:04:AA:AA:AB).
This command disables / enables "Loop Detection"
for a specific port.
This command enables a specific port. It can enable
a port blocked by "Loop Detection".
This command enables / disables the "Recovery"
function on a port.
This command configures the "Recovery Time"
period.
Manual
1.1.0