Table 117: Cli "Sntp" Configuration; Sntp - WAGO 852-1305 Manual

262 Appendix
10.3.2.3

SNTP

Table 117: CLI "SNTP" Configuration

Node
enable
configure
configure
configure
configure
configure
configure
configure
configure
configure
Example
L2SWITCH(config)#time ntp-server 192.5.41.41
L2SWITCH(config)#time timezone operator + hour 8 min 0
Command
show time
time
HOUR:MINUTE:SECON
D
time date
YEAR/MONTH/DAY
time daylight-saving-time This command enables the daylight saving time.
time daylight-saving-time
start-date <month> <day>
<hour>
time daylight-saving-time
end-date <month> <day>
<hour>
no time daylight-saving-
time
time ntp-server
IP_ADDRESS
no time ntp-server
time timezone operator
(+|-) hour (VALUE 0~14)
min (VALUE 00 or 30)
WAGO-ETHERNET-Zubehör 852
852-1305 8/4-Port 100BASE-T/1000BASE-SX/LX
Description
This command displays the current time and date
configurations.
This command sets the current time of the switch.
hour: 0-23
min: 0-59
sec: 0-59
Note: If you configure daylight savings time after
you configure the date and time, the switch uses
daylight savings time.
This command sets the current date of the switch.
year: 1970-
month: 1-12
day: 1-31
This command sets the start date of daylight savings
time.
This command sets the end date of daylight saving
time.
This command disables daylight saving time on the
switch.
This command sets the IP address of the time server.
This command disables the NTP server settings.
This command sets the time difference between UTC
(formerly GMT) and the time zone.
Manual
1.1.0