Table 93: Wbm "Arp Inspection" Page - "Arp Inspection" Tab - WAGO 852-1305 Manual

216 Configuring in the Web-Based Management System (WBM)
Table 93: WBM "ARP Inspection" Page – "ARP Inspection" Tab
ARP Inspection Settings
Parameters
State
VLAN State
Trusted
Ports
ARP Inspection Status
Parameters
ARP Inspection State
Enabled on VLAN
Trusted Ports
Default
Disable
Enable
Add
Delete
Select All
Deselect All
 1 ...
 10
Default
Disable
Enable
None
1 ... 10
Nonr
1 ... 10
852-1305 8/4-Port 100BASE-T/1000BASE-SX/LX
Description
Select "Disable" in the selection box if you want to
disable ARP inspection on the switch.
Select "Enable" in the selection box if you want to
enable ARP inspection on the switch.
Select "Add" in the selection box and enter the
VLANs for which "ARP Inspection" should be
enabled on the switch.
Valid range of VLAN IDs: 1 ... 4094.
Use a comma (,) or hyphen (-) to specify individual
VLANs or VLAN ranges.
Select "Delete" in the selection box and enter the
VLANs on which the switch should not run "ARP
Inspection".
Select the ports that you want to select or deselect as
"Trusted Ports".
The switch does not drop ARP packets from
"Trusted Ports" for any reason.
The switch discards DHCP packets from "Untrusted
Ports" in the following situations:
• The sender information in an ARP packet does
not match any current bindings.
• The transmission rate of the DHCP packets
received are too high. You can specify the
maximum rate for receiving packets on
"Untrusted Ports".
No port is selected as "Trusted".
 
All ports are selected as "Trusted".

No port is disabled as "Trusted".
 
All ports are disabled as "Trusted".

The port is not enabled.
 
The port is enabled.

Description
This field displays the current status of the ARP
inspection.
This field displays the VLAN IDs for which ARP
Inspection is enabled.
This field displays the ports specified as "Trusted
Ports".
WAGO-ETHERNET-Zubehör 852
Manual
1.1.0