Table 81: Wbm "Loop Detection" Page - WAGO 852-1305 Manual

196 Configuring in the Web-Based Management System (WBM)

Table 81: WBM "Loop Detection" Page

Loop Detection Settings
Parameters
Status
MAC Address
Port
State
Action
Loop Recovery
Recovery Time (min)
(Range: 1~60)
Loop Detection Status
Parameters
Port
Status
Status
Loop Recovery
Recovery Time (min)
Default
Disable
Enable
From: 1
To: 1
Disable
Enable
None
Unblock
Enable
Disable
1
Default
1 ... 10
Enable
Disable
None
Normal
Enable
Disable
1 ... 50
WAGO-ETHERNET-Zubehör 852
852-1305 8/4-Port 100BASE-T/1000BASE-SX/LX
Description
Select "Disable" in the selection box to disable this
function.
Select "Enable" in the selection box to enable this
function.
Enter the destination MAC address in the input field
to which the probe packets should be sent. If the port
receives the same packets, it is shut down.
Select a port or port range in the selection box for
which you want to configure the "Loop Guard
Protection" settings.
Select a port or port range in the selection box for
which you want to configure the "Loop Guard
Protection" settings.
Select "Disable" in the selection box to disable this
function.
Select "Enable" in the selection box to enable the
"Loop Guard" function for the switch.
Select "None" in the selection box if you disable
loop detection on the port.
Select "Unblock" in the selection box if you do not
want to change the "Status" and "Loop Correction"
functions.
Select "Enable" in the selection box to automatically
enable the port again after the designated "Recovery
Time" has elapsed.
Select "Disable" in the selection box to disable this
function.
Enter the value for the "Recovery Time" (in
minutes) in the input field that the switch waits
before enabling the port again.
Time: 1 ... 60 min
Description
This column displays the port numbers.
This column displays if the "Loop Guard" function
is enabled or disabled.
This column displays if a port is blocked.
This column displays if the "Loop Recovery"
function is enabled or disabled.
This column displays the "Recovery Time" for the
"Loop Recovery" function.
Manual
1.1.0