Table 146: Cli "Access Control List" Configuration; Access Control List - WAGO 852-1305 Manual

284 Appendix
10.3.4.6

Access Control List

Table 146: CLI "Access Control List" Configuration

Node
enable
configure
configure
acl
acl
acl
acl
acl
acl
acl
acl
acl
acl
acl
acl
acl
acl
acl
acl
acl
acl
acl
Command
show access-list
access-list STRING
no access-list STRING
show
action (disable | drop |
permit)
destination mac host
MACADDR
destination mac
MACADDR MACADDR
destination mac
MACADDR MACADDR
no destination mac
ethertype STRING
no ethertype
source mac host
MACADDR
source mac MACADDR
MACADDR
no source mac
source ip host IPADDR
source ip IPADDR
IPMASK
no source ip
destination ip host
IPADDR
destination ip IPADDR
IPMASK
no destination ip
l4-source-port IPADDR
no l4-source-port
IPADDR
WAGO-ETHERNET-Zubehör 852
852-1305 8/4-Port 100BASE-T/1000BASE-SX/LX
Description
This command displays all access control profiles.
This command creates a new access control profile.
Where "STRING" is the profile name.
This command deletes an access control profile.
This command displays the current access control
profile.
This command activates this profile.
"disable": The profile is disabled.
"drop": If packets match the
profile, the packets are
dropped.
"permit": If packets match the
profile, the packets are
forwarded.
This command configures the destination MAC
address and the mask for the profile.
This command configures the destination MAC
address and the mask for the profile.
This command configures the destination MAC
address and the mask for the profile.
The second "MACADDR" parameter is the mask
(e.g., ffff.ffff.0000) for the profile.
This command deletes the destination MAC address
from the profile.
This command configures the ETHERNET type for
the profile. Where the "STRING" is a hexadecimal
value. e.g.: 08AA.
This command deletes the ETHERNET type limit
from the profile.
This command configures the source MAC address
and mask for the profile.
This command configures the source MAC address
and mask for the profile.
This command deletes the source MAC and mask
from the profile.
This command configures the source IP address for
the profile.
This command configures the source IP address and
mask for the profile.
This command deletes the source IP address from the
profile.
This command configures a specific destination IP
address for the profile.
This command configures the destination IP address
and mask for the profile.
This command deletes the destination IP address
from the profile.
This command configures the UDP/TCP source port
for the profile.
This command deletes the UDP/TCP source port
from the profile.
Manual
1.1.0