Table 120: Cli "Blackhole Mac" Configuration; Table 121: Cli "Port Mirroring" Configuration - WAGO 852-1305 Manual

264 Appendix
10.3.2.6 Blackhole MAC

Table 120: CLI "Blackhole MAC" Configuration

Node
enable
configure
configure
10.3.2.7 Port Mirroring

Table 121: CLI "Port Mirroring" Configuration

Node
enable
configure
configure
configure
configure
Example
L2SWITCH#configure terminal
L2SWITCH(config)#mirror enable
L2SWITCH(config)#mirror destination port 2
L2SWITCH(config)#mirror source ports 3-10 mode both
Command
show mac-address-table
refusal
mac-address-table refusal
MACADDR vlan
VLANID
mac-address-table refusal
MACADDR
Command
show mirror
mirror (disable|enable)
mirror destination port
PORT_ID
mirror source ports
PORT_LIST mode
(both|ingress|egress)
no mirror source ports
PORT_LIST
WAGO-ETHERNET-Zubehör 852
852-1305 8/4-Port 100BASE-T/1000BASE-SX/LX
Description
This command displays the current rejected MAC
address only.
This command configures the rejection of a MAC
address in a specific VLAN.
This command configures the rejection of a MAC
address.
Description
This command displays the current "Port Mirroring"
configurations.
This command disables / enables the "Port
Mirroring" on the switch.
This command specifies the monitor port for the
"Port Mirroring".
This command adds a port or port range as the
source port(s) for the "Port Mirroring".
This command removes a port or port range as the
source port(s) for the "Port Mirroring".
Manual
1.1.0